My new little friend .

John ED Renstrom

PCS Member - Elected Director 2019-2022
Super Site Supporter
The Pinner one i have used the same black and cream colors. All most the same lay out on the blank panels. To.
 

John ED Renstrom

PCS Member - Elected Director 2019-2022
Super Site Supporter
They did have a raised cup and a flush one. The weight of the body was to keep in in place. After all no need for speed or wild driving at that point.
 

Paul Steinberg

Administrator
Staff member
Super Site Supporter
Unless both sides are different, then it was intended to be canted. Leave it alone if that is the case. Look at the old pictures also. That was installed by Flxible at the factory, so why mess with it?
 
Last edited:

John ED Renstrom

PCS Member - Elected Director 2019-2022
Super Site Supporter
One look inside will tell if it was Felexable or some one wanted to be different. But some were out there has to be a picture of the offerings that year. But that is the standard Service car tri. Piece.
 

Daniel Scully

PCS Member
Site Supporter
Unless both sides are different, then it was intended to be canted. Leave it alone if that is the case. Look at the old pictures also. That was installed by Eureka at the factory, so why mess with it?
Before this goes down a rabbit hole, this was made by Flxible.
 

Paul Steinberg

Administrator
Staff member
Super Site Supporter
I'm Flxible, so call it anything you want. I will correct the error of the body manufacturer. Peter Rabbit
 
Top