Mounting rocker moldings

[Jim Staruk]

I'm mounting my rocker moldings onto my '75 Superior. The body has 8 single holes for the clips and 9 screw holes for the bottom of the molding on each side. Does anyone know what clip I need.. or better yet, anyone have the clips I need?

 

[Daniel Scully]

Clips

Jim ,This is what my 68 Superior uses , I think it is the same as what you need. It screws to the body and the top of the molding slides into it and the bottom of the molding screws to the rocker.

 

[Peter Grave - Deceased - 1938 - 2022]

Don't get too upset about only using the correct retainer many GM and other makes use very similar (and will work as well) retainers. Largely used on vehicles with WIDE mldgs. check your local U-Pull it yard.

 

[Jim Staruk]

Jim ,This is what my 68 Superior uses , I think it is the same as what you need. It screws to the body and the top of the molding slides into it and the bottom of the molding screws to the rocker.

Thanks Dan. Any part # on that?

 

[John ED Renstrom]

that is a MM Design they use it on the front fender and sometimes on the dog leg. in between On the 69 also but on the 75 it had tabs chopped out of flat stock. Eureka is using that same type of homemade hanger as that. and so did superior. there are round ones that GM used available on both plastic or steel. AVECKO has them. all it does is allow the molding to hang on it then it screwed into the rocker threw the slotted holes. GM has used any number of tabs that screw on to the body to hain on the top. here are the set from the Eureka sn the set I put on the 64 I can get you the avecko number if you need it. there the ones I used on the 64

 

[Daniel Scully]

Thanks Dan. Any part # on that?

No numbers but I have pulled these from a # of Superiors in the yards from the mid 60,s to the mid 70,s.