Hi again. I had sort of posed this question towards the end of another thread but decided to give it its own thread in hopes of getting an answer before I talk to the steel cutting/fabrication guys.
The rear bumper I bought was missing one of the spacers where the ends connect (my understanding is this goes on the inside and the bolts go through it). I need to know if the bend that you can just about see in this picture is manufactured or if it is supposed to be flat and this one somehow got bent.
Or in the unlikely even that someone has a pair or one of these that I could buy, that would work too. Here is the pic.
The rear bumper I bought was missing one of the spacers where the ends connect (my understanding is this goes on the inside and the bolts go through it). I need to know if the bend that you can just about see in this picture is manufactured or if it is supposed to be flat and this one somehow got bent.
Or in the unlikely even that someone has a pair or one of these that I could buy, that would work too. Here is the pic.